jump to navigation

Temp Probe – DS18B20 — 3 wire configuration and tested May 11, 2011

Posted by rik94566 in aquaponic automation, aquaponics, arduino, DIY aquaponics, DS18B20, indoor aquaponics, indoor gardens, sensor, Stainless Steel Temp Probe, Standards, Temperature Probe.
Tags: , , , , , , , , , , , , ,
trackback

Here is how I got my DS18B20 Stainless Steel Temp probe connected using a 3 wire configuration.  This set up uses BLACK – RED – YELLOW leads out of the temp probe.

3 wire connection - resister between Signal and Power

Correct reading were generated with this configuration.  This result comes from sketch that was shown in the 5/8/2011 post.  Please go there if you would like a copy of the sketch.

Correct readings are generated

 

Here is the results from running the sketch:

 

Advertisements

Comments»

No comments yet — be the first.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: