WATER TIGHT model — Sketch-UP plug-in needed February 3, 2013Posted by rik94566 in agponics.com, CEA, DIY aquaponics, Rj45 connector, Sketch-UP, Standards.
Tags: aquaponic automation, DIY aquaponics, indoor aquaponics, rik kretzinger, sensor
With a little research on my end I found the Sketch-Up plug-in that had very good help features. The product is CADspan.
You can down load it here if you have a need for this type of product: http://www.cadspan.com/tools
Here is a YouTube to help you visualize what is possible with this technology: