jump to navigation

agponic MD — adding cable gland to the container November 12, 2013

Posted by rik94566 in agponic MD, agponics.com, aquaponics, DIY aquaponics, Internet-of-Farming, IoT aquaponics.
Tags: , , , , , ,
trackback

An important aspect to making the agponic MD unit work is making sure the containers are water tight.  There are a large number of holes made to accommodate the many mounting screws and allow sensor wires to pass from the tank container and grow bed container.  Without addressing this issue early on one will only encounter leaks and problems once the unit is together.

STEP ONE —  The parts

parts

STEP TWO  — Mark where the hole should be before drilling

mark hole

STEP THREE  — prep to drill

This is a very important step, if you do not take extra careful steps you will crack the plastic with the drill bit and you will be starting over.  Support is needed behind the plastic.

tool support

STEP FOUR  — make the hole

drill

STEP FIVE  —  assembly the parts in the hole

assembly

STEP SIX  — test the install —  important last step

test

Advertisements

Comments»

No comments yet — be the first.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: