agponic MD – connecton box left side features February 12, 2014
Posted by rik94566 in agponic MD, agponicMD, agponics.com, aquaponic automation, aquaponics, aquaponics electronics, arduino, DIY aquaponics, DO sensor, indoor aquaponics, indoor growing, Internet-of-Farming, IoT aquaponics, One-wire, PRODUCTS, Slide Switch, Slide Switch.Tags: aquaponic automation, aquaponic crop, DIY aquaponics, DS18B20, indoor aquaponics, microcontroller, rik kretzinger, Temp Probe
add a comment
Here is the configuration of the left side of the connection box.
Slide Switch – wire configuration complete April 14, 2013
Posted by rik94566 in agponics.com, aquaponic automation, aquaponics, aquaponics electronics, DIY aquaponics, indoor aquaponics, IoT aquaponics, Slide Switch.Tags: aquaponic automation, aquaponics, DIY aquaponics, IoT, rik kretzinger
add a comment
Here is how I did my slide switch so I could move from two different power sources. It worked the way I thought it would, but until I actually connect things up I am never sure. The basic concept is that all positive (RED) wires come off one side of the switch and the negative (BLACK) wires come off the other side. It does not matter which is which, you just need to be consistent so you can duplicate the results on future projects. Each one of the power sources are at the ends of the slide switch. Again it does not matter how you connect it up, but each source needs to be opposite of each other. Configured this way the center prongs will be passed power depending on which end you have the slide positioned.
“SLIDE SWITCH LAYOUT”
Aquaponic DIY Automation Blog 